Gasboy Fuel Point PLUS Vehicle - Manual (Page 93)

Fuel Point PLUS Vehicle Installation and Configuration Manual 93
Step Display Description/Action
52 Switch Timeout. Default: 30 Minutes. Save or
edit the parameter and save
53 Engine On report option. Default: N
Press ENTER to leave the option disabled
Change default to Y to enable the option
54 Press SEND
55 Wait a few seconds until the DP and VIU
programming process finishes.
Continue to Step 62, except for the following:
56 The following options are available when
using WP ARM ver. 2.1.16, AVR ver. 4.3.6
and up, DP ver. 4.2 and up:
The number of FP units correlated to the DP is
displayed.
To add another FP (for an additional
tank), place the WP coil near the FP coil
and press Y.
Proceed to Step 57
Press N to finish the process and return to
the WP Functions main menu (Step 2)
Note: The system supports up to five different
FP devices per vehicle. After 5 FP units were
successfully programmed the option to add
FP becomes unavailable and a success
message is displayed
57 Enter the allowed fuel type code.
Proceed to Step 54.
58 The following screens appear if the Replace
FP option was selected (Step 12, WP ARM
ver. 2.1.16, AVR ver. 4.3.6 and up, DP ver. 4.2
and up):
The number of remaining functional FP devices