Gasboy Fuel Point PLUS Vehicle - Manual (Page 114)

Fuel Point PLUS Vehicle Installation and Configuration Manual 114
Step Display Description/Action
units found:
6 Use the DOWN arrow key to move the pointer
(>) to the required DP address
7 Wait a few seconds until the WP recognizes the
DP
8 Vehicle ID is displayed. Reenter Vehicle ID for
confirmation
9 Fleet Code is displayed. Save or edit the
parameter and save
10 Enter the allowed fuel type code
11 Vehicle code is displayed. Save or edit the
parameter and save.
Save/edit DP parameters, as follows:
Proceed to Step 13 in Table 4-10 for
DP Heavy
Proceed to Step 13 in Table 4-13 for
DP Light
Proceed to Step 13 in Table 4-15 for
μDP
After setting DP parameters, the following screen is displayed:
Press SEND to set DP parameters
An operation successful screen is displayed.