Gasboy Fuel Point PLUS Vehicle - Manual (Page 56)

Fuel Point PLUS Vehicle Installation and Configuration Manual 56
3-6.
HEAVY VEHICLES INSTALLATION
3-6.1.
General
Obtaining Odometer and Engine hours in heavy vehicles can be done in two ways:
Connecting DataPass to odometer pulses output (directly, or via tachograph's pulses output)
Connecting the DataPass to the vehicle bus, which allows retrieving additional information
from the vehicle computer
3-6.2.
Connecting the DataPass to Odometer Pulses Source
A simple way to retrieve odometer pulses is from the truck’s tachograph output.
Installation of the DataPass requires disassembling the vehicle's tachograph and accessing its rear
side wiring in order to connect the DataPass harness to the tachograph's wiring.
Table 3-11 depicts the connections running between the tachograph and the DataPass. There are
common types of tachographs where Pulse output pin number differs from each other; refer to
Table 3-12. to locate the applicable pin number according to tachograph type and model.
Table 3-11. Tachograph – DataPass Harness Connections
DataPass Harness Wire Tachograph
White Pulse output
Red VIN+
Black VIN-
Blue Vehicle switch
Table 3-12. Pulse Output Pin in Various Types of Tachographs
Tachograph Types
Pulse
output
Notes
VDO Kienzle Type – 1310 C3 / #4
PIN #4 is an alternative in cases
where C3 is available
VDO Kienzle Type – 1314 C3
VDO Kienzle Type – 1315 Z4
VDO Kienzle Type – 1318 B8 / D3 / B7 D3 / B7 are alternatives in cases
where B8 is available
VDO Kienzle Type – 1319 B8 / D3 / B7 D3 / B7 are alternatives in cases
where B8 is available
VOLVO Motometer
Type EGK100 ,EGK100-01
B7 / B8 / B3 B8 / B3 are alternatives in cases
where B7 is available
MAZ truck B7
Perform the following steps: