Gasboy Fuel Point PLUS Vehicle - Manual (Page 30)

Fuel Point PLUS Vehicle Installation and Configuration Manual 30
2-6.
HEAVY DUTY VEHICLES INSTALLATION
2-6.1.
General
In order to provide a solution for various fuel tank inlets in different truck models, the following
installation configurations are available:
Long Neck Fuel Inlet Installation
Short Neck Fuel Inlet Installation
Self installation
The coil unit is placed around the fuel inlet. Positioning the Fuel Ring as far as possible from the
surface of the truck, achieves better performance. The coil should be installed using Gasboy's
molded Fuel Ring clamps. Those clamps are used to achieve sufficient distance from the fuel tank
inlet and from the fuel tank surface for maximum performance. The ID chip is secured against theft
and is damaged when pulled away from the vehicle after installation is completed.
2-6.2.
Preliminary Instructions
WARNING
Before installing or servicing equipment, carefully
observe the warnings and precautions provided at
the beginning of this manual.
NOTE
Warranty does not cover defects or damage caused
by improper installation.
In order to prevent possible problems and difficulties during the installation, please verify that:
1. The coil in use is larger than the fuel tank inlet diameter by approximately 0.984" (25mm)
2. The coil is assembled as close as possible to the inlet cap, without interfering with the
opening and closing of the fuel tank inlet cover
3. In cases where the fuel tank is made of aluminum, a gap of at least 76mm" is maintained
between the coil and the tank and also between the coil and the fuel inlet (larger coil is
recommended)
4. In cases where the Security cover is used, it is positioned as close as possible to the fuel inlet
and to a side wall to prevent rotation or any movement which could damage the ID chip or
the wiring
5. The coil cable is protected from harsh environment by a metal conduit
6. The ID chip is placed in a less accessible location for prevention of theft and tampering
7. The ID chip is not secured to the fuel tank. The Fuel Ring cable is long enough to allow
placing the ID chip in a safe and hidden place inside the truck (a distance of up to 100cm
between the coil and the ID chip is permitted)