Gasboy Fuel Point PLUS Vehicle - Manual (Page 117)

Fuel Point PLUS Vehicle Installation and Configuration Manual 117
4-11.
ADD DP TO FP
Add DP to FP option enables the technician to program a DP unit and to correlate it with an already
programmed Fuel Ring.
NOTE
Fuel Ring units may not be reprogrammed after
being associated to a DP.
Table 4-19 describes the Add DP to FP sequence steps common to all DP types.
Verify that the DP is powered (turn ignition switch ON).
Turn on the WP; follow the instructions appearing on the WP display, described below.
Table 4-19. Add DP to FP Sequence
Step Display Description/Action
1 Enter user ID
Enter password
2 The WP Functions menu is displayed. Use the
DOWN arrow key to move the pointer (>) to the
Add DP to FP option
3 Place the WP coil near the vehicle's fuel inlet
and then press SEND
4 Wait a few seconds until the WP recognizes the
Fuel Ring
5 Program the newly added unit, as follows:
Proceed to Step 9 in Table 4-10 for DP
Heavy
Proceed to Step 9 in Table 4-13 for DP
Light