Gasboy Fuel Point PLUS Vehicle User Manual
Page 35
Fuel Point PLUS Vehicle Installation and Configuration Manual
35
Figure 2-20. Complete Coil Installation on Short Neck Inlet
2-6.4.3. Self Installation
Self installation is performed where both long neck and short neck fuel inlet installations cannot be
performed. The coil is equipped with a rubber membrane, which attaches the coil firmly to the fuel
tank inlet using pressure.
Proceed as follows:
1. Use a Fuel Ring of optimal size which can be easily placed around the fuel tank inlet and
allows the opening and closing of the fuel tank inlet cover (use a coil larger than the fuel
tank inlet diameter by approximately 25 mm)
NOTE
Raise the coil as much as possible to bring it close to
the fuel inlet (less than 30mm), and verify that the
coil does not interfere with the opening and closing
of the fuel tank inlet cover.
2. Install a metal band around the fuel tank inlet and underneath the coil. to prevent the coil
from sliding down
3. Install the coil on the fuel tank inlet applying pressure (see Figure 2-21)
Figure 2-21. Complete Coil Self – Installation
2-6.5.
Chip Installation
2-6.5.1. Installing the Chip with a Security Cover
In order to install the ID chip using a Security cover, proceed as follows:
1. Close the fuel inlet cover
2. Choose an optimal and secure position for the Security cover