Gasboy Fuel Point PLUS Vehicle - Manual (Page 14)

Fuel Point PLUS Vehicle Installation and Configuration Manual 14
Figure 1-1. Fuel Point PLUS System Architecture
1-3.
MANUAL STRUCTURE
This manual comprises the following sections:
Section 1: Introduction
This section provides a general description of the Fuel Point PLUS system in general.
Section 2:
Fuel Ring Description and Installation
This section provides a detailed of the Fuel Ring units and comprehensive installation instructions
for light/heavy vehicles.
Section 3: DataPass & µDataPass Description and Installation
This section provides a detailed of the DataPass & µDataPass units and comprehensive installation
instructions for light/heavy vehicles.
Section 4: Programming Vehicle Units
This section provides instructions on the programming sequence of the vehicle units installed in
private and heavy duty vehicles using the Wireless Programmer device, as well as instructions for
setting up the WP.
Section 5: Troubleshooting
This section provides a list of common problems related to the vehicle units or to its communication
with the Fuel Point PLUS system, as well as corrective action instructions.
Section 6: Glossary
Includes a glossary of terms used in the manual.
Appendix A: Finding DP Calibration Factors For New OBD-II Vehicle Models
This appendix describes the procedure for finding out calibration factors of DP/μDP units' odometer
reading for new vehicle models equipped with OBD-II systems.
1-4.
USING THIS MANUAL
This manual includes comments planted along the text, in order to draw the reader’s attention to
important issues. The comments are accompanied by symbols for ease of reference. The following
comment types are used:
WARNING
An operating procedure, practice or similar, if not
correctly followed, could result in injury or loss of
life.