Gasboy Fuel Point PLUS Vehicle - Manual (Page 25)

Fuel Point PLUS Vehicle Installation and Configuration Manual 25
compartment, at the sides if possible, but not at the bottom, as the fuel nozzle may
damage the ID chip while refueling. The surface must be flat for better gluing and to
ensure that the unit is not damaged by pressure applied during installation
4. Using a soft sandpaper (e.g. #300), slightly sand the area where the ID chip is to be
glued. Pay attention not to damage the car color
5. Clean thoroughly the surface on which the coil and ID chip are to be placed using a
clean cloth and cleaning solution
6. The ID chip is installed with glue with the option of using a special screw, which is also
included in the kit:
a. In the designated area (see Figure 2-8), drill a 0.094" (2.4 mm) diameter hole. Be
careful not to drill through the fuel tank. Upon drilling completion, make sure to
clean the area before applying the glue
CAUTION
Drilling should be performed by authorized
personnel equipped with a dedicated drilling
machine.
Figure 2-8. ID Chip Preferred Position
b. Insert the one-way special screw into the ID chip (see Figure 2-9)