Gasboy Fuel Point PLUS Vehicle - Manual (Page 96)

Fuel Point PLUS Vehicle Installation and Configuration Manual 96
Step Display Description/Action
29 Switch Timeout. Default: 30 Minutes. Save or
edit the parameter and save
30 Engine On report option. Default: N
Press ENTER to leave the option disabled
Change default to Y to enable the option
31 Press SEND
32 Wait a few seconds until the DP and VIU
programming process finishes.
Continue to Step 39, except for the following:
33 The following options are available when
using WP ARM ver. 2.1.16, AVR ver. 4.3.6
and up, DP ver. 4.2 and up:
The number of FP units correlated to the DP is
displayed.
To add another FP (for an additional
tank), place the WP coil near the FP coil
and press Y.
Proceed to Step 34
Press N to finish the process and return to
the WP Functions main menu (Step 2 in
Table 4-10)
Note: The system supports up to five different
FP devices per vehicle. After 5 FP units were
successfully programmed the option to add
FP becomes unavailable and a success
message is displayed
34 Enter the allowed fuel type code.
Proceed to Step 31
35 The following screens appear if the Replace
FP option was selected (Step 12 in Table 4-10,
WP ARM ver. 2.1.16, AVR ver. 4.3.6 and up,
DP ver. 4.2 and up):