Gasboy Fuel Point PLUS Vehicle - Manual (Page 111)

Fuel Point PLUS Vehicle Installation and Configuration Manual 111
Step Display Description/Action
5
Use the DOWN arrow key to move the pointer
(>) to the required DP address
6
Wait a few seconds until the WP recognizes the
DP.
Continue to Step 9, except for the following:
7 In cases where the current DP version is old,
users may update DP firmware (i.e. update DP to
DP+):
Press Y to update
Press N to continue the current process
8
In cases where the DP has been previously
programmed, approve re-programming: press Y
9
The Organization Name is displayed.
If the WP is associated to several HO, select the
required organization
10
1. Enter Vehicle ID (8 characters)
2. Reenter Vehicle ID for confirmation
11
Enter fleet code (4 characters).
Program the unit, as follows:
Proceed to Step 13 in Table 4-10 for
DP Heavy
Proceed to Step 13 in Table 4-13 for
DP Light
Proceed to Step 13 in Table 4-15 for
μDP
After setting DP parameters, the following screen is displayed:
Press SEND to set DP parameters