Basler Electric BE1-851 - Manual (Page 160)

Table 8-2. Factory Default Function Blocks Logic Settings
Function Purpose
BESTlogic
Expression
Mode
Setting
50TP Used for instantaneous phase overcurrent protection. 0 1 (enabled)
50TN Used for instantaneous neutral overcurrent protection. 0 1 (enabled)
50TQ
Used for instantaneous negative-sequence overcurrent
protection.
0 1 (enabled)
150TP N/A 0 1 (enabled)
150TN N/A 0 1 (enabled)
150TQ N/A 0 1 (enabled)
51P Used for timed phase overcurrent protection. 0 1 (enabled)
51N Used for timed neutral overcurrent protection. 0 1 (enabled)
51Q Used for timed negative-sequence overcurrent protection. 0 1 (enabled)
62 N/A 0 0 (disabled)
162 N/A 0 0 (disabled)
79 N/A 0 0 (disabled)
BF N/A 0 0 (disabled)
GROUP
Input 0 Logic: No manual selection logic is used. 0
1 (discrete
input
selection)
Input 1 Logic: No manual selection logic is used. 0
Input 2 Logic: No manual selection logic is used. 0
Input 3 Logic: No manual selection logic is used. 0
Auto/Manual Logic: Set to 1 (/0) to enable automatic
selection. No manual selection is used.
/0
Table 8-3. Factory Default Virtual Switch Logic Settings
Switch Purpose Mode Label
State Labels
True False
43 N/A 1 (Off/On/Pulse) SWITCH_43 TRUE FALSE
143 N/A 1 (Off/On/Pulse) SWITCH_143 TRUE FALSE
243 N/A 1 (Off/On/Pulse) SWITCH_243 TRUE FALSE
343 N/A 1 (Off/On/Pulse) SWITCH_343 TRUE FALSE
101
Virtual Control Switch to
trip bus breaker.
1 (enable) N/A N/A N/A
8-4 BE1-851 Application 9289900990 Rev R