Basler Electric BE1-851 - Manual (Page 103)

SECTION 6 • REPORTING AND ALARMS
General
This section describes all of the reports that are available from the BE1-851 relay, how to set the reporting
functions, and how to retrieve these reports. This section also describes all of the alarm functions, how to
set those functions, and how to program (map) the major and minor alarms. In all instances in this section
where reporting is concerned, the relay must be connected to a PC running BESTCOMS™ for reporting to
be available through the BESTCOMS software. For help in connecting the relay, see Section 12,
Installation.
Relay Identifier Information
BE1-851 relays have two relay identification fields: Relay ID and Station ID. These fields are used in the
header information lines of the Fault Reports, the Oscillographic Records, and the Sequence of Events
Records. Relay and station identification assignments are made from the General Operation screen in
BESTCOMS. To open the General Operation screen, select General Operation from the Screens pull-
down menu. Then select the General Information tab. The fields are located in the lower right hand corner
of the screen. Alternately, these assignments can be made using assignments can be made using the
SG-ID ASCII command. Table 6-1 outlines the range and default for these two fields.
Figure 6-1. General Operation Screen, General Information Tab
Table 6-1. Circuit Identification Parameters
Identification Field Range Default
Relay ID 1 to 10 alphanumeric characters. BE1-851
Station ID 1 to 30 alphanumeric characters. SUBSTATION_1
9289900990 Rev R BE1-851 Reporting and Alarms 6-1