Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 95)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
95
Format Prefix
9864 9844 9854
Indicates the start of a MLI format instruction.
xxH
Default: xx = 5E (0x5E = Caret)
Delimiter Char
9864 9844 9854
Used as a parameter place marker in MLI format instructions.
xxH
Default: xx = 2C (0x2C = Comma)
Label Top
9864 9844 9854
Label top offset (y-offset) in dots. Equals the parameter PRINT PARAMETERS >
Y-print offset , which is ignored, when MLI print jobs are printed.
xxx Dots
Setting range: -120 - +120; Default: 0; Step width: 1
Left Position
9864 9844 9854
Left position offset (x-offset) in dots. Equals the parameter PRINT PARAMETERS >
X-print offset , which is ignored, when MLI print jobs are printed.
xxx Dots Setting range: -9999 - +9999; Default: 0; Step width: 1
Manual Calibrate
9864 9844 9854
For endless (continuous) material, the label length information is sent in the
print job.
For punched (die cut) material, the label length is detected by enabling this
function.
YES
Label length calculation for punched material.
¯
Enable this function when label material is changed and there are no print
jobs loaded.
¯
Shortcut (in offline mode): To calibrate, press Feed and Prog at the same
time.