Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 58)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
58
Light sens. type
9864 9844 9854
Light sensor type
The optional reflex photoelectric switch for labels with reflecting length
markings, or the normal factory-fitted photoelectric switch for labels with
transparent or register gaps (self-adhesive labels), must be defined
according to the application.
Short label opt.
(9854 only) Activates the optional short label sensor.
¯
Appears only in 9854 printers which are equipped with the short label
sensor.
Full Size
Full Size photoelectric switch (Adjustment range is the material width).
Reflex
Reflex photoelectric switch (for reflecting markings)
Punched
Transparent photoelectric switch (for gaps)
Head-sensor dist.
9864 9844 9854
¯
Parameter appears only in production mode or if a value > 0 is set.
Printhead sensor distance
Special function for setting non-standard punch sensors. The value x is the
distance between the thermal edge and punch sensor in millimeters.
x mm Setting range: 0 to 400 mm
¯
A non standard sensor must be installed and connected instead of the
regular punch sensor.
¯
0 = disabled (use the regular punch sensor).
Sens. punch-LS
9864 9844 9854
Sensitivity punch light sensor
Sets the sensitivity of the material photoelectric switch.
xxx mm
Setting range: 10 to 100%; Unit interval: 10%
Default setting: 50%
Maximum sensitivity: 100%. for narrow gaps (perforations).
Minimum sensitivity: 1%. for clearly detectable gaps.
¯
Too high a level of sensitivity leads to gaps being detected that do not
exist (material thickness fluctuations, perforations etc.).