Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 63)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
63
Mat.end detect.
9864
Material end detection.
The material end detection can be disabled when processing labels with gaps
longer than 15 mm, or if using material with a high fluctuation of light
transparency (material end is displayed even though material is present).
¯
CAUTION! - Reel material should not be processed when the material
end detection is disabled! With this setting, printing continues on the print
roller after the end of the material, leading to shorter cleaning intervals or
damage.
Reflex
Material end detection by means of a reflex sensor.
Transparent
Material end detection by means of a transmission sensor.
Disabled
No material end detection.
Periph. device
9864 9844 9854
After installation, select the Peripheral device options so the options function
as expected.
¯
CAUTION! - Selecting an incorrect option can lead to malfunctions or
damage!
None
No peripheral device is installed.
Cutter
Sets the printer firmware to the cutter option. Selection permits access to the
cut parameters.
Rewinder
Sets the printer firmware to the rewinder option. Selection permits access to
the rewinder parameters.
Tear-off edge
Sets the printer firmware to the tear-off edge option. The punch is fed forward
to the tear-off edge.
Dispenser Setting for 9864/9854 dispenser version.
¯
9864 4- & 5-inch only: After selecting this value, the parameter SPECIAL
FUNCTION > Disp. Head Offs. appears automatically. If the parameter SPECIAL
FUNCTION > printhead type is set to “KCE 4 Inch.”
Intern Rewinder 9854 only: Setting for printer operation in internal rewinder mode, that is
operation with a deflector and without dispensing edge.
Tear-off + sensor 9854 only: Setting for using the dispensing edge as tear-off edge.
The punch is fed forward to the dispensing edge.