Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 33)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
33
Batch mode
The entire surface of the label is printable and cutting takes place during
printing. This results in brief interruptions within the print zone of the following
label. The output volume is at the maximum.
Requirements for the batch mode are:
•
Ribbon economy is not active (parameter SYSTEM PARAMETERS >
Ribbon autoecon. = "Deactivated")
•
Material length >18 mm
• Number of cuts for a print job - at least 2 or more
[14] Printing process in Batch mode.
Normal 1:1 Mode
In N1:1 Mode, cutting takes place during printing. The zero-line of the printing
is shifted 18 mm in y-direction. This offset equals the distance of the cutter to
the printhead. Therefore, the first 18 mm of the label are not printable. These
measurements correspond to the distance between printhead and the cutter.
The output volume is at the maximum.
Avery
Avery Avery
Avery
Avery
Avery
Printhead Cutter
1. Printing
2. Stop printing +
cut
3. Continue
printing