Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 11)

1. Only 9864 dispenser with 4-inch printhead 2. Only with 9864 Dispenser and if SYSTEM PARAMETER > Gap detect. mode = Autom. feed back 3. Only with 8-Dot-Emulation 4. Only with 8-inch 5. Only with rewinder
option 6. Only with cutter 7. Only with USI interface 8. Only if SYSTEM PARAMETER > Gap detect. mode = Autom. feed back 9. Only with fonts stored in the flash memory 10. Only with MONARCH LANGUAGE
INTERPRETER™ activated 11. Only with I/O board 12. Only if PRINT PARAMETERS > Punch mode = Manual 13. Only in production mode 14. Only with 9864 dispenser 15. Only if SYSTEM PARAMETERS >
Autom. dot check = Continuous 16. For details read parameter description 17. Only with 4, 5, and 6-inch 18. Only with installed RFID option 19. Only if DP INTERFACE > Interface type = USI Applicator 22. Only
with an activated RFID option 25. With Applicator Interface only 26. Only OLV option activated 27. Only if APPLICATOR PARA > Applicator type = PEP or PEP blow on 28. Not if APPLICATOR PARA > Applicator
type = LTP-LTPV or ASA 29. Availability depends on device configuration 30. Only with a Compact Flash card inserted
06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9864
11
9864
Pa
ra
m
et
er
s
SERVICE FUNCTION (Service Funct. continued) SERVICE DATA (Service Data cont.)
Service 13 Print test > MODULE FW VERS. Serial number 29
Head exchange 13 Rewinder setup 5 System version Operation time 29
Roller exchange 13 Feed driver Total on time 29
Cutter exchange 13/6 Foil driver
Serv. data reset 13 Head driver > CPU BOARD DATA
Head dot test Peripheraldriver 29 CPU identifier
Head step tune 13 Rewinder 29 Syst. controller
EasyPlug monitor 13 USI interface 29 PCB revision
EP Monitor Mode 13 MAC address
Paper jam level 13 > OPERATION DATA Serial number
Head adjust Serv. operations Production date
Sensor adjust 13 Headnumber PCB part number
Sensor test Roll number Board part numb.
Cutter test Cutter number 6 Manufacturer 13
Matend tolerance Head run length Work place 13
Feedadjust label Roll run length Company name 13
Feed adjust Cuts on knife 6
Foil feed adjust 13 Tot. mat. length > DISPLAY DATA
Punch y calibr. 13 Tot. foil length Display version
HME registers 4/13 Total cuts 6
Scanner test Total head moves > MEMORY DATA
CompactFlashTest Head strobes Ram memory size
Send test Foil diameter Flash mem size
Receive test Operation time Space for Jobs
Com2 comun. test 11 Max. Labellength
Com2 port test 11 > POWERSUPPLYDATA Default values
Headvo. adj. 20 V 13/17 Type
Headvo. adj. 28 V 13/17 Version 29
F
W
5.03