Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 78)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
78
Status output
9864 9844 9854
¯
Only with an I/O board installed.
This parameter defines what events generate a MACHINE STATUS.
Low ribbon warn A message appears when the ribbon roll diameter is less than the limit.
P See parameter Foil end warning on page 52.
Print job ready The signal is on when the printer has imaged and is ready to start printing.
The signal is not activated when
• the print job is finished
• the print job is stopped,
•
the printer is switched to offline mode,
•
the printer is in pause mode.
Status polarity
9864 9844 9854
¯
Only with an I/O board installed.
Changes the polarity of the MACHINE STATUS signal.
Level high active
The output is high when it is on, otherwise low.
Level low active
The output is low when it is on, otherwise high. (Default)
End print mode
9864 9844 9854
¯
Only with an I/O board installed.
Sets how the output signal PRINT_END at the I/O board signal interface is
handled. Determines the signal response after printing a label.
Mode0 inactive
No print end signal.
Mode1 high level Low when the print module prints a label, otherwise high.
The output is also off (low) as long as labels are fed by pressing Feed or
“Feed Signal
.”
Mode2 low level
High when the print module prints a label, otherwise low.
The output is also off (high) as long as labels are fed by pressing Feed or
“Feed Signal.”
Mode3 low pulse
(Default setting) Low for 20 ms after printing and dispensing a label.
The output is also activated (= low) after a label is fed with “Feed Button” or
“Feed Signal”.
Mode4 high pulse
High for 20 ms after printing and dispensing a label.
The output is on (high) after a label is fed by pressing Feed or “Feed Signal.”