Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 91)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
91
Ribbon signal
9864
¯
Only with USI board.
Sets a WARNING at the USI when the ribbon or material is almost out.
Enabled (Default setting) High when the ribbon stack is less than the threshold value.
P The threshold setting is done with the parameter SYSTEM PARAMETER >
Foil end warning .
Disabled
Ribbon signal off.
Material signal
9864
¯
Only with USI board.
Sets a WARNING at the USI when the ribbon or material is almost out.
Enabled High when the diameter of the material roll falls below a certain value. The
limit diameter is set by positioning the outer diameter (OD) sensor.
¯
Requirement: "OD sensor material" is installed.
Disabled
No material end warning.
Mat. signal stop
9864
¯
Only with USI board.
Sets the printer reaction to a material low signal from the OD sensor.
P See DP INTERFACE > Material signal
Disabled
(Default) Sets a WARNING at the USI if (precondition: DP INTERFACE > Material
signal is set to enabled). The printing continues.
Enabled
After a material low warning, the printer finishes printing the current label and
stops. You see
Acknowledging the message to continue printing.
Print Status: 5123
USI Material low