Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 83)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
83
DISPENSER PARAMETERS
Dispense Mode
9854
¯
Only if SYSTEM PARAMETER > Periph. device = Dispenser.
Sets the print-dispense procedure.
¯
The ribbon autoeconomy function can only be used in Real 1:1 Mode!
Normal 1:1 Mode • The printer cannot print on the whole label surface. A stripe at the beginning
of the label remains unprinted.
• The label is dispensed while printing.
•
The output volume is at the maximum.
¯
The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge + Dispense position (see [13])
P See parameter PRINT PARAMETERS > Dispense position .
P A graphic can be found under PRINT PARAMETERS > Cut mode > Normal 1:1 mode .
[17] The size of the non-printable area in Normal 1:1 depends of the setting of parameter
"SYSTEM PARAMETERS/ Dispense Position".
Dispensing edge Distance print line to dispensing edge
long 39.8 mm
short 24.2 mm
[13] A stripe of the width "distance print line to dispensing edge + dispense position" can not
be printed in "Normal 1:1 Mode.
a b c
Label
Backing paper
Printing
Printhead
Dispensing
Edge
Feed
Direction
Non-printable area with
Dispense
Dispense
a) Dispense position = 0
b)
position < 0
c) position > 0
Z0137E.ep
s