Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 25)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
25
Material type
9864 9844 9854
Defines the material type being used.
Reel material and gapped (die cut) material (hole gaps, self-adhesive
material with register gaps). The detected gap position corresponds to the
start of the label.
¯
The value is overwritten by the appropriate Easy Plug command when
sending label formats.
Endless
(Continuous)
If material is to be used without gaps.
Punched (Die Cut)
If material is to be used with gaps (default setting).
Material length
9864 9844 9854
The material length (label length) is the distance between the gaps,
measured from the front edge (beginning) of a label to the front edge of the
next label.
¯
The value is overwritten by the appropriate Easy Plug command when
sending label formats.
xxx mm
Setting range: 5 mm to max. length entry; Unit interval: 0.1 mm
Default setting: 100 mm
Maximum length entry: depends on the printhead width and memory
configuration.
Material width
9864 9844 9854
The zero position of the left border. If the printer is working in line-printer,
make changes in millimeters.
xxx mm Setting range: min. width to max. width; Unit interval: 0.1 mm
Default setting: 100 mm
• Min. width: depends on the printer type
•
Max. width: depends on the printhead width and memory configuration.
P See the “Specifications” section for more information.