Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 84)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
84
Batch Mode •
The printer can print the entire label surface.
•
The label dispenses while printing. The next label prints after the previous
label is removed.
• The output volume is at the maximum.
¯
Batch mode is optimized for printing and dispensing at high speeds. It is
not possible to use all features available in modes Normal 1:1 or Real 1:1.
¯
Do not use the following Job/Parameter combinations:
•
Jobs with counter fields
•
Jobs with variable fields
• SYSTEM PARAMETER > Dispensing mode must be set to fast.
• The USI reprint function is not supported. DP INTERFACE > Reprint signal must be
set to deactivated.
•
Foil save
P A graphic can be found under PRINT PARAMETERS > Cut mode > Batch mode .
Real 1:1 Mode
(Default setting)
• The printer can print the entire label surface.
• After dispensing a label, the beginning of the next label is backed up under
the printhead.
•
The output volume is lower than in Batch Mode or Normal 1:1 Mode.
P A graphic can be found under PRINT PARAMETERS > Cut mode > Real 1:1 mode .
Dispenseposition
9854
¯
Only if SYSTEM PARAMETER > Periph. device = Dispenser.
Dispense position
Adjusts the dispense (peel) position in or out against the feed direction.
Labels stick to more or less of the backing paper based on the setting
(Fig. 11).
[18] Dispense position (stop position) of the dispensed label.
x.x mm
Setting range: -30.0 to +20.0 mm; Unit interval: 0.1 mm; Default
setting: depends on the setting of the parameter
SYSTEM PARAMETERS >
Application mode (see [14]).
Dispensed label Dispense position
Dispensing edge
Backing paper
Z0040E
.cdr