beautypg.com

Applicator para, Applicator type – Avery Dennison Monarch 9864 Info Printouts and Parameters User Manual

Page 72

background image

06/08 Rev. AB

USER MANUAL

Info-Printouts & Parameters

9844 - 9854 - 9864

72

APPLICATOR PARA

¯

This menu only appears in printers of the types when the optional

Applicator Interface (AI) is connected.

Applicator type

9864

¯

Only with Applicator Interface.

Applicator type selection:

LTP-LTPV

LTP = Light Touch Pneumatic
LTPV = Light Touch Pneumatic Vacuum
Applicator with Light Touch function. The movement of the (compressed air)
cylinder is limited by sensors, which react to a light touch onto the product.
The LTPV applies the labels with a vacuum nozzle.

Advantages:

Application on products with different heights

Only light pressure onto the product (for fragile products)

PEP

The cylinder movement is limited by a specified time. After the time expires,
the cylinder moves back into the home position.

PEP Blow on

PEP-type applicator with blow on function: After the time expires, the blow on
function applied. After the blow on time expires, the applicator moves back
into the home position.

PEP II Sensor

The cylinder movement is limited by a (touch down) sensor, which signals the
contact to the product and triggers the backwards-movement.

ASA

ASA = Air stream applicator. This applicator type has no moving parts, but
blows the label onto the product (blow box). After the start signal, the blow on
valve is opened for a specified time limit.

Reverse PEP

This applicator is partly time related.
The applicator moves to its end position and waits for the start signal.
The start signal triggers the blow on valve for a set amount of time.
After the time expires, the applicator moves to the home position, gets the
next label, and moves to the wait position.

Direct Dispense

Dispensing with dispensing edge (without applicator).

BTS

BTS = Bad tag separator. This device does the opposite of an applicator: it
removes labels from the dispensing edge. Use the BTS to sort RFID labels
that could not be read/written properly.

O-ring applicat.

Setting for an O-ring applicator.