beautypg.com

Receive test – Avery Dennison Monarch 9864 Info Printouts and Parameters User Manual

Page 106

background image

06/08 Rev. AB

USER MANUAL

Info-Printouts & Parameters

9844 - 9854 - 9864

106

Receive test

9864

9844

9854

Use this test to see if the printer can receive data serially or with the parallel
port.

Serial connection:

The printer must be connected to the host; the parameter

INTERF.PARAM. >

Interface

must be set on RS232 or RS485.

1. Start MS-DOS.

2. Set the transmission parameters used by the printer with the MS-DOS

Command Mode.

Example of printer settings:

– Baud rate: 19200
– Data bits: 8
– Parity: none
– Stop Bits: 1
– Data synch.: RTS/CTS

DOS-Command: mode com2 19200 8 n 1
(if com2 is the serial port)

3. Press Online to start the receive test.

4. Send any file to the printer, for example:

copy anyfile.txt com2

You see:

xxxxxx is the size of the sent file in bytes. This value is calculated during the
test. The test is complete when the file size at the printer matches the size
visible in the MS-DOS window. Otherwise, transmission errors occurred.

Parallel connection:

The parallel connection must be set to Centronics in the parameter

INTERF.PARAM. > Interface

.

1. Call the parameter

SERVICE FUNCTION > Receive test

and press Online.

2. Start MS-DOS.

Receive test
0 Bytes

Receive test
xxxxx Bytes

Receive test
0 Bytes