Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 59)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
59
Ribbon autoecon.
9864
Ribbon automatic economy mode
Pause the ribbon feeding to save ribbon when printing long labels with
minimal print. Use for unprinted areas from approx. 10 mm in length.
You must select thermal transfer or thermal direct printing before you can use
the ribbon end detection.
Thermal printing
Thermal direct printing (Ribbon-end-LS turned off)
Enabled
(not with 9844 or 9854)
Thermal transfer printing with ribbon automatic economy mode on.
Disabled
Thermal transfer printing with ribbon automatic economy mode off.
Ribbon economy limit
9864
Sets the length of the area where there is no printing.
x.xx mm
Setting range: xx up to 100 mm; Unit interval: 0.1 mm (the initial value
depends on the feed speed)
Default value: 5.0 mm
Foil mode
9844 9854
Thermotransfer
Thermotransfer printing (Ribbon sensor enabled)
Thermal printing
Thermodirect printing (Ribbon sensor disabled)
Turn-on mode
9864 9844 9854
Operating mode of the printer after it is turned on.
Online
Printer starts in online mode.
Offline Printer starts in offline mode.
Standalone
Printer starts in standalone mode.
Interface delay
9864 9844 9854
After switching from online to offline mode, the printer interface is disabled.
Set a time delay before you disable the interface.
xxxx ms
Setting range: 0-1000; Unit interval: 100; Default setting: 0