Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 76)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
76
Reprint Signal
9864 9844 9854
¯
Only with an I/O board installed.
Disabled
The input signal is off.
Enabled The last label reprints on the falling edge of the REPRINT signal.
Preconditions:
• The label to be reprinted should be printed and dispensed.
• Printer is online.
If a REPRINT is triggered while the printer is in I/O Board Pause mode, the
reprint proceeds when the printer is switched to online mode. Level mode
START PRINT must be inactive.
Feed input
9864 9844 9854
¯
Only with an I/O board installed.
Sets how the input signal FEED at the signal interface is handled.
Enabled
(Default setting) Feeds one label on the falling signal edge. The display
shows “I/O board feed” while feeding.
Preconditions:
•
Offline mode, stopped mode or pause mode
• Online mode and no print job loaded.
Disabled
Signals at the FEED input are ignored.
Pause input
9864 9844 9854
¯
Only with an I/O board installed.
Sets how the input signal PAUSE at the signal interface is handled.
Disabled
Signals at the PAUSE input are ignored.
Pause
A high-low transition switches the printer into I/O-Board Pause mode. The
next high-low transition switches the printer back into the online mode. If
parameter
I/O-Board > Start print mode is set to Level high active or Level low active,
any change to the PAUSE signal stops the printing after the current label.
Features:
•
Printer display shows “I/O-Board pause”
•
ERROR is active (if I/O Board > Error output is set to Printer err+Offl)
• If a print job is available: DATA READY becomes inactive (if I/O Board > Status
output is set to Print job ready)
• START PRINT signals are suppressed.
• REPRINT requests are processed after switching into online mode.