Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 29)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
29
Dispense Mode
¯
9864: Dispenser version only.
Sets the print-dispense procedure.
¯
The ribbon autoeconomy function can only be used in "Real 1:1 Mode"!
Dispense only
P See parameter PRINT PARAMETERS > Material length .
After setting "Dispense only," the printer restarts. Then, you see
Press Prog from offline mode to access the parameter menu.
Normal 1:1 Mode •
The printer cannot print on the whole label surface. A stripe at the beginning
of the label remains unprinted.
• The label is dispensed during printing.
• The output volume is at the maximum.
¯
The width of the unprintable stripe is calculated as follows:
Distance print line to dispensing edge + Dispense position (see [5])
P See parameter PRINT PARAMETERS > Dispense position .
P A graphic can be found under PRINT PARAMETERS > Cut mode > Normal 1:1 mode .
Dispense only
Labels 0 0 = Number of dispensed labels.
Dispensing
edge Distance print line to
dispensing edge
long 39.8 mm
short 24.2 mm
[5] A stripe of the width "distance print line to dispensing edge + dispense position" can not
be printed in "Normal 1:1 Mode.