Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 40)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
40
Number of data bits
9864 9844 9854
This parameter can be defined for both the serial and the parallel interface.
7
7 Data bits
8 8 Data bits
Parity
9864 9844 9854
Defines the parity check of serial transmitted data.
The parity bit is for checking data transmission. If the check shows an error,
a corresponding message is displayed. The setting must be identical at the
sender and the receiver. Normally, transmission is set without a parity bit.
Odd
Odd parity.
A parity bit is added so that there is an odd number of 1 Bits.
Even
Even parity.
A parity bit is added so that there is an even number of 1 Bits.
None
No check bit. Sending and receiving without check bit.
Always zero Check bit is always 0 (zero). Sending and receiving without parity check.
Stop bits
9864 9844 9854
Number of stop bits
Number of stop bits at the serial interface.
1 Bit
1 stop bit
2 Bit
2 stop bits
Data synch.
9864 9844 9854
Data synchronization at the serial interface.
RTS/CTS
Data synchronization through hardware.
XON/XOFF
Data synchronization through software.
None
Handshake signals are ignored.