Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 60)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
60
Error reprint
9864 9844 9854
If an error occurs while a label is printed, the last printed label is reprinted. Do
not use the error reprint function with labels containing variable data (count
fields).
Enabled
Reprint in error cases (default setting)
Disabled
No reprint in error cases.
Single job mode
9864 9844 9854
In single job mode (also stop mode) the printer stops after every job and waits
until the operator restarts the print process.
Deactivated
Single job mode is turned off (default setting).
Activated
Single job mode is turned on. The printer always displays “Start next job,”
before starting a new print job. Press Online to acknowledge.
Head resistance
9864 9844 9854
For optimum print quality, set the individual printhead resistance.
When replacing the printhead, re-enter the resistance value from the label
applied to the printhead.
¯
CAUTION! - Entering an incorrect value can damage the printhead!
« Use the value from the label applied to the printhead.
¯
This value remains even if factory settings are applied.
xxxx Ohm
Setting range: 1000 to 1500 Ohm; Unit interval: 1 Ohm
Setting the printhead resistance:
Setting:
1. Make a note of the setting from the printhead label (1000 to 1500).
2. In offline mode, press Prog. You see PRINT INFO.
3. Press Cut until you see SYSTEM PARAMETER.
4. Press Online. You see
5. Press Cut until you see
SYSTEM PARAMETER
Foil end warning
SYSTEM PARAMETER
Head resistance