Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 34)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
34
[15] Printing process in Normal 1:1 Mode.
Cut speed
9864
¯
Only with an attached and enabled cutter ( SYSTEM PARAMETERS >
Periph. device = Cutter).
Adjust the cut speed based on the material thickness and strength.
x inch/s
Setting range: 2 to 5 ips; Unit interval: 1 ips
• 2 ips: extremely slow; for thick and strong material
• 5 ips: extremely fast; for thin material
Cut position
9864
¯
Only with an attached and enabled cutter ( SYSTEM PARAMETERS >
Periph. device = Cutter).
The cut position is identical to the detected gap position (with the start of the
label). To make small adjustments, use the parameter
PRINT PARAMETER > Cut
position .
x ips
Setting range: -2.0 to +2.0 mm; Unit interval: 0.1 mm
• Maximum offset in feed direction: -2.0 mm
• No offset: 0 mm
•
Minimum offset against feed direction: -2.0 mm
Avery
Avery
Avery
Avery
Printhead Cutter
1. Printing
2. Printing
End
3. Feeding
4. Cutting