Feedadjust label – Avery Dennison Monarch 9864 Info Printouts and Parameters User Manual
Page 103

06/08 Rev. AB
USER MANUAL
Info-Printouts & Parameters
9844 - 9854 - 9864
103
Feedadjust label
9864
9844
9854
Prints a scale to calculate the feed adjust value (see next parameter).
Required label material: minimum length 4 inches (100 mm), optimum length
8 inches (200 mm).
To calculate the feed adjust:
[21] Feedadjust label with printed-on measure scale (C) and calculation scheme (D).
1. Load label material.
2. Measure the distance between the two marks “Start of meas.” [21B] and
“End of meas.” [21E].
3. Put the measured distance into the calculation below:
%
4. Calculate the feed adjust. Enter the result into the
SERVICE FUNCTION >
Feedadjust
parameter.
5. Print another feed adjust label and check the position of the black squares
[21A] or the first line of the scale. They must be printed exactly on the label
edge. If not, go to step 6:
6. Measure the distance between the black squares and the label front edge.
Enter the value into
SERVICE FUNCTION > Punch y calibr.
. Repeat steps 5 and 6
until the black squares are flush with the label front edge.
Start
of
meas.
End
of
meas.
Feed adjust =
* 100%
180 - measured length
180
B
E
D
A
C
Feedadjust
180
measuredLength
–
180
----------------------------------------------------------- 100
⋅
=