Avery Dennison Monarch 9864 Info Printouts and Parameters - Manual (Page 35)

06/08 Rev. AB USER MANUAL Info-Printouts & Parameters
9844 - 9854 - 9864
35
Double cut
9864
¯
Only with an attached and enabled cutter ( SYSTEM PARAMETERS >
Periph. device = Cutter).
The double cut cuts the gap (perforation) between labels. The labels are
attached to the liner and the perforation between labels is removed.
The first cut is offset by the distance set from the recognized gap position
away in the feed direction and the second cut is made at the gap position.
x ips
Setting range: 0.0 to 5.0 mm; Unit interval: 0.1 mm
Normal simple cut: 0.0 mm
¯
Use the smallest possible double cut distance of 1.0 mm.
Rewind direction
9864 9854
¯
Only with an attached and enabled cutter ( SYSTEM PARAMETERS >
Periph. device = Rewinder).
Determines the rotation direction of the optional rewinder.
Printing outside Rewind direction: The printed label is facing outside.
Printing inside
Rewind direction: The printed label is facing inside.
X - print offset
9864 9844 9854
The printing zero point is moved on the X- axis (lengthways to the material).
¯
If the setting is changed while the print job is stopped, the printer
recalculates the format using the changed values.
¯
Use caution with graphics generated with one of the Easy Plug
commands #YI, #YIR or #YIB! If the graphic is shifted beyond the label
border, the part of the graphic beyond the border is not printed.
x inch/s Setting range: -5.0 to +5.0 mm; Unit interval: 0.1 mm
Default setting: 0.0 mm
• Maximum offset away from the edge of the label: +5.0 mm
• No offset: 0.0mm
•
Maximum offset towards the edge of the label: -5.0 mm