Altera Mentor Verification IP Altera Edition AMBA AXI3/4TM - Manual (Page 677)

Getting Started with Qsys and the BFMs
Setting Up Simulation from the Windows GUI
Mentor VIP AE AXI3/4 User Guide, V10.2b 657
September 2013
3. Qsys displays the connectivity of the selected example as shown in Figure 12-5 .
Figure 12-5. Quartus II Software Displays Connectivity of the Example
Note
If you are using VHDL, you must select each BFM and verify that the index number
specified for the BFM is correct. An information dialog displays the properties of the
BFM when you select it. Ensure the specified BFM index is correct in this dialog. If you
do not know the correct index number, check the VHDL code for the BFM.
4. Select the Generation tab on the upper right side of the window (refer to Figure 12-5 ) to
display the netlist generation options.
5. Specify the netlist generation options and generate the netlist ( Figure 12-6 ).
Figure 12-6. Generation Tab Window