Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 99)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
5-3
5.3 Installing the servo amplifier
5 Installation
5.3 Installing the servo amplifier 5300 Installing the servo amplifier 5- Montage_protego_D ` Materials: 3 hexagon socket cylinder head screws DIN 912, M5
` Required tool: Hexagonal wrench 4 mm
Proceed as follows:
` Drill M5 holes in the control cabinet's mounting plate, as shown in the
illustrations.
` Remove the fan underneath the servo amplifier (see section in this
chapter entitled: “Installing and removing the fan”).
` Attach the servo amplifier to the mounting plate in your control cabi-
net,
` Replace the fan underneath the servo amplifier.
INFORMATION
Remove the fan before installing the servo amplifier.
Replace the fan once the unit is installed. See section entitled:
“Installing and removing the fan”.