Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 23)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
3-1
3.1 Intended use
3 Safety
3 3000 Safety Safety 3- 3.1 Intended use 3100 Intended use 3- ][Sicherheit_Bestimmung_protego_D
The servo amplifiers PMCprotego D are designed to drive suitable
brushless, synchronous servo motors and asynchronous motors with
closed loop speed, torque and/or position control.
][Sicherheit_Bestimmung_Ausschluss
The following is deemed improper use:
` Any component, technical or electrical modification to the servo am-
plifier
` Use of the servo amplifier outside the areas described in this manual
` Use of the servo amplifier outside the documented technical details
(see chapter entitled “Technical Details”)
Intended use includes making the installation and wiring EMC-compli-
ant. Please refer to the guidelines stated in this manual.
3.1.1 Hazard analysis
Hazard analysis 3- ][Sicherheit_Bestimmung_Gefahrenanalyse
The machine manufacturer must produce a hazard analysis for the ma-
chine. He must take appropriate measures to ensure that unexpected
movements do not lead to hazardous situations for either people or
equipment.
3.1.2 Electrical data
Electrical data 3- ][Sicherheit_Bestimmung_elektrisch_protego_D
Please note the electrical requirements stated in the chapters entitled
“Technical Details”, “Wiring” and “Function Description”.
3.1.3 Ambient conditions
Ambient conditions 3- ][Sicherheit_Bestimmung_Umgebung
Please note the following conditions for using the servo amplifier:
` Operation of the servo amplifier is forbidden in the following condi-
tions:
– Potentially explosive areas
– Environments containing corrosive and/or conductive acids, alka-
line solutions, oils, fumes or dusts
– Where there is a direct connection to unearthed or asymmetrically
earthed mains supplies with U
N
> 240 V. See chapter entitled “Wir-
ing”, section on “Mains voltage”.
– On ships and offshore installations
` The servo amplifier may only be operated in an enclosed control cab-
inet in compliance with the ambient conditions defined under “Tech-