Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 15)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
2-3
2.1 Unit structure
2 Overview
Operation and display
` Servo amplifier operated via two keys
` Three-digit LED display for status and messages
][Ueber_Merkmale_integrierte_Sicherheit
Integrated safety
` Device safety
– Safe electrical isolation between mains voltage/motor connection
and control element, in accordance with EN 61800-5-1
– Soft start, overvoltage detection, short circuit protection, phase
failure monitoring
– Temperature monitoring of servo amplifier and motor (when using
Pilz motors with ready-made cables)
` Protection of personnel and plant
– Safety function STO – Safe torque off
Single-channel without feedback: Up to PL d (Cat. 2) of
EN ISO 13849-1 and SIL CL 2 of EN/IEC 62061
Dual-channel with feedback: Up to PL e (Cat. 4) of EN ISO 13849-
1 and SIL CL 3 of EN/IEC 62061
– Slot for safety card: Safety functions for safe operation of drive
axes in accordance with DIN IEC 61800-5-2, up to PL e (Cat. 4) of
EN ISO 13849-1 and SIL CL 3 of EN/IEC 62061
Ueber_Merkmale_Schnittstellen_protego_D
Communications interfaces
` CANopen interface for
– Connection to CAN bus systems
– Parameters for several drives can be set via a servo amplifier's se-
rial interface
` RS 232 interface for parameter setting with the PDrive commissioning
software
` 2 Ethernet interfaces (in development)
][Ueber_Merkmale_SD_protego_D
SD card
` Read/write device for SD card, for reading and writing parameters
and firmware
Ueber_Merkmale_Erweiterungen_protego_D
Expansion cards
3 slots for expansion cards
` Expansion cards for slot 1:
– I/O-14/08
– PROFIBUS
– DeviceNet
– SERCOS