Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 123)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
6-19
6.6 Power element
6 Wiring
Use the following fuses for F
B1
and F
B2
, depending on the device type.
US types in brackets
6.6.4 Intermediate circuit
Intermediate circuit 6- ][Verdr_Leiterquerschnitte_Verweis
Under “Connection cables”, please note the requirements for the:
` Cable cross sections
` Insulation material
][Verdr_Zwischenkreis_protego_D
The connections for the intermediate circuit are
` not short circuit and earth fault proof
` Not reverse polarity protected.
][Funktion_Zwischenkreis_Wichtig
Fuse
Device type 01, 03 06 12 24
Blow-out fuse or similar 6 AT
(FRS-6) 10 AT
(FRS-10) 16 AT
(FRS-16) 25 AT
(FRS-25)
Connector pin assignment
Connector X8 Pin Designation Description
1 -DC Intermediate circuit voltage -DC
2 +Rbe/+DC Intermediate circuit voltage +DC
Connection
Output/input circuit Intermediate circuit
Cable runs
≤
200 mm:
Use unshielded single wires
(2.5 mm²)
Cable runs > 200 mm:
Use shielded cables.
X8
-DC 1
+RBe 2
+RBi 3
-RB 4
1
RBe/+DC
2
PMCprotego X8
-DC
PMCprotego X8
1
2
PMCprotego
RBe/+DC
-DC