Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 174)

7.1 Safety guidelines
7 Commissioning
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-2
` Only specialist staff with extensive knowledge of drive technology
and control engineering should be permitted to program a running
drive online.
` Data stored on data media is not protected from unintended changes
by third parties. Data must be checked for accuracy before it is down-
loaded to the control system.
` Prior to installation and commissioning, information in this operating
manual, and in particular the safety guidelines, must be carefully read
and considered (see Chapter entitled “Safety”). Personal injury and
material damage may result if devices are handled incorrectly.
` it is essential to comply with the technical details and specifications
(type label and documentation).
` Life-threatening voltages up to 900 V are present. Check that all live
connections are safely protected against contact.
` The heat sink and front plate temperature on the amplifier may reach
80°C during operation. Check (measure) the temperature of the heat
sink. Wait until the heat sink has cooled to 40°C before touching it.
][Inbetrieb_Sicherheit_D_01_24 ` Never unplug the electrical connections on the servo amplifier while
voltage is applied. Residual charges in the capacitors may still carry
hazardous voltages up to 8 min. after the mains voltage has been
switched off (5 min. for 1.5 to 12 A types, 8 min. for 24 A types).