Pilz PMCprimo DriveP.01/AA0/4/0/0/208-480VAC - Manual (Page 82)

4.4 Expansion cards
4 Function Description
Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-50
4.4.6 Expansion card with DeviceNet interface
Expansion card with DeviceNet interface 4- ][Funktion_Erw_DeviceNet_protego_D
The DeviceNet expansion card is available as an accessory.
Fig. 4-16: Front view of DeviceNet expansion card
LEDs
The “Net status” LED shows the status of both the expansion card and
the network.
Setting the station address
Valid values for the station address are 0 … 63
D
.
` Use the two rotary switches under “Address” to set the station ad-
dress.
There are three ways in which you can set the servo amplifier's station
address:
LED Description
Off The device is offline.
- The device has not yet completed the Dup_MAC_ID test.
- The device may not be switched on.
Green The device is online and is running normally. The connec-
tions are established. The device is assigned to a master.
Flashes green The device is online and is running normally. The connec-
tions are not established.
- The device has passed the Dup_MAC_ID test and is online,
but the connections to other nodes are not yet established.
- This device has not been assigned to a master.
- Configuration is missing, incomplete or invalid
Flashes red Recoverable error and/or at least one I/O connection is in
wait status.
Red - An unrecoverable error has occurred on the device. It may
need to be exchanged.
- Communication device has failed. The device has detected
an error that's preventing communication with the network
(e.g. duplicated MAC ID or BUSOFF).