AMT Datasouth Journey II - Manual (Page 90)

80
General Printer - Error Messages Description and Corrective Action
Off line:Reject Bin Full
Press RESET to Continue
This message indicates the REJECT BIN
is full. This condition is detected by the
Reject Bin Full Sensor, which is used to
detect when the REJECT BIN is holding
approximately 50 coupons.
This error can occur when:
•
The REJECT BIN is full.
•
The printer is not sensing coupons in
the REJECT BIN correctly.
To correct this error:
1. Unlock and open the OUTPUT BIN
DOOR.
2. Press and hold the REJECT BIN
LEVER in the lowered position.
3. Remove all coupons from the
REJECT BIN.
4. Release the REJECT BIN LEVER
and ensure it returns to the raised
position.
5. Close and lock the OUTPUT BIN
DOOR.
6. Press the RESET key to clear the
message and continue.
Recovery Messages Description of Message
Exiting Diagnostics
< Please Wait > This message indicates the printer is in
the process of terminating one of the
diagnostic print functions. The
termination process may take a few
seconds.
Reinitializing
< Please Wait > This message indicates the printer is in
the process of recovering from a printer
error condition. The recovery process
may take a few seconds.