AMT Datasouth Journey II - Manual (Page 108)

98
Flash Memory Test Mode Messages Description of Message
Flash Erase Error
Press RESET to Continue
This message indicates the printer
detected an error when erasing flash
memory.
This error can occur when:
•
A flash memory component fails.
To correct this error:
1. Press the RESET key to terminate the
test.
2. Power the unit off.
3. Unlock and open the BIN 1 ACCESS
DOOR and remove entire cover set.
4. Replace failed component or entire
Main Controller PCB.
7. Reattach the cover set and close and
lock the BIN 1 ACCESS DOOR.
5. Power the unit on.
Flash Write Error
Press RESET to Continue
This message indicates the printer
detected an error when writing to flash
memory.
This error can occur when:
•
A flash memory component fails.
To correct this error:
1. Press the RESET key to terminate the
test.
2. Power the unit off.
3. Unlock and open the BIN 1 ACCESS
DOOR and remove entire cover set.
4. Replace failed component or entire
Main Controller PCB.
8. Reattach the cover set and close and
lock the BIN 1 ACCESS DOOR.
5. Power the unit on.