AMT Datasouth Journey II - Manual (Page 103)

93
Printer Calibration - Error Messages Description and Corrective Action
Off line: Error: R-POS
Press RESET to Continue
This message indicates an error
occurred, in the Reject Bin Position
Sensor (R-POS), during the sensor
calibration procedure.
This error can occur when:
•
Media dust or debris obstructs the
Reject Bin Position Sensor.
•
The Reject Bin Position Sensor or
Reject Bin Position Motor cable fails
or is not connected properly.
•
The Reject Bin Position Sensor or
Reject Bin Position Motor fails.
•
A component fails on the Main
Controller PCB.
To correct this error:
1. Perform the cleaning procedures and
vacuum out all media dust and debris
(especially remove all dust inside the
REJECT BIN and OUTPUT BIN
sensors).
2. If this error continues, power the unit
off and check internal cable
connections.