AMT Datasouth Journey II - Manual (Page 52)

42
Cleaning the Rollers
NOTE: Perform the previous Cleaning the Coupon Path
instructions before cleaning rollers.
1. After vacuuming the coupon path, leave the BIN 1 ACCESS DOOR open
and unload any existing coupons from the STOCK LOAD KNOB A rollers
by turning the knob clockwise. Unload the coupons from the BIN 2 INPUT
SLOT (gently pull the coupon back and out of the slot.).
2. Remove the ATB Roller Cleaning Card from its protective pouch and
insert it into the STOCK LOAD KNOB A rollers with a one-quarter (¼)
turn counter-clockwise, like a normal coupon. Close and lock the BIN 1
ACCESS DOOR.
3. Press the ON LINE/MENU button to go Off line. Then press the
RESET/CLEAN, and ENTER buttons, in that order, to start the cleaning
operation.
4. After the automatic cleaning operation is complete, unlock and open the
BIN 1 ACCESS DOOR and the ZONE 1 ACCESS DOOR. Remove the
cleaning card from the top rear of the printer.
5. With the ZONE 1 ACCESS DOOR still open, allow 10 minutes for the
cleaning solution to fully dry.
6. Firmly close and lock the ZONE 1 ACCESS DOOR (making sure that the
catch is seated under the latch) and reload coupons into the STOCK LOAD
KNOB A rollers.
7. Close and lock the BIN 1 ACCESS DOOR and press the ON LINE/MENU
key to go On line.
8. Reload coupons in BIN 2.
Figure 4-2. Cleaning the Rollers
MAGNETIC
HEADS
CLEANING
CARD EXIT
LOCATION ROLLERS
ROLLER