AMT Datasouth Journey II - Manual (Page 121)

111
1. Press the ON LINE/MENU key to place the printer Off line.
2. Press the FEATURE з
з key until the ‘Software Rev.’ feature is displayed.
3. Press the ENTER key.
4. Press the FEATURE и
и key to display the following features.
CAUTION: Only qualified users/service technicians
should select this menu.
Feature Values Description
Output Bin Override
## 0 to 50 After the OUTPUT BIN sensor detects a
full condition it will accept an additional
number of coupons (set here) before a full
condition is shown on the LCD.
Reject Bin
Override ## 0 to 15 After the REJECT BIN sensor detects a
full condition it will accept an additional
number of coupons (set here) before a full
condition is shown on the LCD.
Profile Lockout Enabled
Disabled This feature enables or disables the four
Profile Select keys.
Calibrate Sensor N/A This feature will calibrate the coupon
detection sensors. To run this test, you
must first place a stack of 50 flat
coupons in the REJECT BIN and a stack
of 190 flat coupons in the OUTPUT BIN.
N: ##, G: ##, P: ##,
P: ##, H: ## N/A Feature displays first five sensor values.
E: ##, O: ##,
RB: ##, OB: ## N/A Feature display next four sensor values.
Mag Calibration N/A This feature is used to calibrate printer
magnetics when excessive magnetic verify
errors occur or a new type of ticket stock
is used.
B1: ###, ####:
B2: ###, #### N/A This feature displays the mag calibration
values for BIN 1 and BIN 2.
Aux Port: COM 2
LPT1 Selects the type of auxiliary port.
Auxiliary Port Test N/A This feature is used to transmit a test
pattern out of the COM2 (itinerary printer
port) serial port. Press the ENTER key to
initiate the test.
Feature Values Description