AMT Datasouth Journey II - Manual (Page 20)

10
14. To load BIN 2, place a maximum of 1,000 coupons at the back of the
printer, directly behind and aligned with the BIN 2 INPUT SLOT. Orient
the coupons as shown on the BIN 2 label.
15. Insert the staple tab end or leading edge of the coupon squarely into the
document slot (with the print surface facing up). The BIN 2 INPUT SLOT
has a sensor that automatically detects and loads the document. (Both Bins
should now be loaded with coupon stock.)
16. Place the printer Off line by pressing the ON LINE/MENU key.
17. Press the FEATURE з
з (left arrow) key until the ‘Print 1 Test Coupon’
message appears in the display.
18. Press the ENTER key.
19. One test coupon will print with a character ripple pattern (and magnetic test
pattern on the magnetic stripe if magnetics is enabled).
20. If no errors occurred during this test, the printer is ready for host
environment configuration.
21. Refer to the Troubleshooting section of the manual if an error occurs.
Figure 1-5. Loading Coupons into BIN 2 (acceptable methods)