AMT Datasouth Journey II - Manual (Page 107)

97
Flash Memory Test Mode Messages Description of Message
Test Complete
Press RESET to Continue
This message indicates the printer
successfully completed the Flash
Memory Test. As a result of this test, the
contents of the Test ROM Module are
copied into flash memory. This includes
both new boot and system software. All
other non-volatile storage is initialized to
factory default conditions.
To operate the printer from flash
memory:
1. Press the RESET key to continue.
2. Power the unit off.
3. Unlock and open the BIN 1 ACCESS
DOOR and remove entire cover set.
4. Unplug the Test ROM Module from
the debug connector slot and orient
the two jumpers on J7 horizontally.
5. Reattach the cover set and close and
lock the BIN1 ACCESS DOOR.
6. Power the unit on.
OS Checksum Error
Press RESET to Continue
This message indicates the printer
successfully completed the Flash
Memory Test but detected an error when
validating the software it copied from the
Test Module into flash memory. As a
result of this test, new boot software
remains in flash memory but the system
software does not.
This error can occur when:
•
The Flash Memory Test is run from
the Engineering Test RAM Module.
This test cannot run successfully
from the Engineering Test RAM
Module.
To correct this error:
1. Press the RESET key to terminate the
test.