AMT Datasouth Journey II - Manual (Page 110)

100
Disk Drive Test Mode Messages Description of Message
Format Failure
Press RESET to Continue
This message indicates the printer
detected an error while formatting the
diskette.
This error can occur when:
•
The floppy disk is bad.
•
The floppy disk drive power or data
cable fails or is not connected
properly.
To correct this error:
1. Press the RESET key to terminate the
test.
2. Insert a good diskette into the Floppy
Disk Drive.
3. If this error continues, power the unit
off and check internal cable
connections.
Write Failure
Press RESET to Continue
This message indicates the printer
detected an error while writing data to
the diskette.
This error can occur when:
•
The floppy disk is bad.
•
The floppy disk drive power or data
cable fails or is not connected
properly.
To correct this error:
1. Press the RESET key to terminate the
test.
2. Insert a good diskette into the Floppy
Disk Drive.
3. If this error continues, power the unit
off and check internal cable
connections.