Plntucklng, Quilting, Pintucking – Kenmore 385.19365 User Manual
Page 97
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Plntucklng
® stitch pattern:
(D Thread tension dial:
(D G: Blind hem foot
Ot
AUTO
Place the folded fabric under the presser foot Position the
folded fabric under the presser foot Position the needle
1/16" {0,1 to 0.2 cm) inside from the folded edge by turning
the handwheel and lower the presser foot. Adjust the
sliding guide on the blind hem stitch foot to the folded edge
by turning the guide screw.
Pppri thp fnldpd cimrtrjihlv
thp Qlldinn nisidp
After sewing is finished^ use an Iron to make pleats.
Quilting
® stitch pattern:
(D Thread tension dial:
(D A: Zigzag foot
® H: Straight stitch foot
®
Qui Iter
01
AUTO
Note:
When using the straight stitch foot, make sure to use
center needle position. Otherwise the needle may
strike the sewing foot and possibly break.
m The guiiter wili keep the stitching lines straight. Loosen
the quiiter screw. Slide the quilter in the opening to the
desired width and tighten the screw.
S Sew guiding the quiiter over the previous row of
stitches.
(
1
) Quiiter holding screw
(D Quiiter
®
Hole
(3) Distance