beautypg.com

Starting to sew continued), O to change the stitch width, To change the stitch density – Kenmore 385.19365 User Manual

Page 81

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

background image

(Starting to sew continued)

HI Raise the buttonhole foot and draw the garment with

both needie and bobbin threads away about 4” (lOcm)

and cut off.

Pull the bobbin thread so that the needle thread is

pulled out to the wrong side of fabric.

Knot both threads under the fabric.

Piace a pin on the rear side of the bartack position so

that you do not need to worry about cutting the end of

buttonhoie stitch.

Cut the opening with the buttonhole opener in your

accessory box.

® Pin

($) Buttonhoier opener / Seam ripper

(D

Punch (use for BH 3)

[Ш After sewing the butìonhoie stitch, raise the buttonhole

lever until it stops.

® Buttonhole ¡ever

Adjusting the Stitch Width and Density In

Buttonholes

o To change the stitch width

The stitch width key controls the stitch width.

The pre-set buttonhole widths are: square buttonhole

5.0,

rounded buttonhoie 4.0, keyhole buttonhole 7.0.

Press V o r t o adjust the stitch width of the entire

buttonhoie, ranging between 2.5 to 7,0 depending on

the selected buttonhole.

® Narrower width by pressing

© Wider width by pressing

o To Change the Stitch Density

The stitch length key controls the stitch density.

The pre-set density varies from 0.4 to 0,7 according to

the buttonhole selected.

Press V’ or to adjust the stitch density of the entire

buttonhole between 0.2 to 1.0 depending on the

selected buttonhole.

Press V’ or to adjust the stitch density between 0.5

to 1.0 for the buttonhole density for | |.

© Denser stitch by pressing

® Coarser stitch by pressing V.

70