Kenmore 385.19365 User Manual
Page 83
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Automatic Buttonhole (BH2/BIH3)
® BH2 sewing steps
Ф Stitch pattern:
BH2
Ф
Thread tension dial:
AUTO
® R: Automatic buttonhole foot
@ Starting point
® Baitacking
* Sewing procedure is the same as BH1.
BH3 sewing steps
Ф Stitch pattern:
BH 3
® Thread tension dial:
AUTO
@ R: Automatic buttonhole foot
® Starting point
® Bartacking
Sewing procedure is the same as BH1,
Ф ®
Щ ^
Note: See page 70 to make the hole of the key hole
buttonhole
Adjusting the Stitch Width and Density In
Buttonholes 2 and 3
® To change the stitch density
The adjustment of the stitch density is between 0.2 to
0.8 the same as BH1. (refer to page 70)
** Adjustment of the stitch width on
buttonhole 2
When you press the zigzag width key, the pre-set
buttonhole width is set for the rounded buttonhole at
4.0, Press “+" or to adjust the stitch width of the
entire buttonhole between 2.5 to 5.5.
© Width: 2.5
©Width;
4.0
©Width: 5.5
® Adjustment of the stitch width on
buttonhole 3
When you press the zigzag width key, the pre-set
buttonhole width is set for the keyhole buttonhole at 7.0.
Press or
to adjust the stitch width of the entire
buttonhole between 5.5 to 7.0.
©Width: 6.5
©Width; 6.0
©Width: 7.0
У